6
CHANGES AND T YPING ERRORS RESERVED
CHANGES AND T YPING ERRORS RESERVED
6.2 d
epTh
adjusTmenT
The depth adjustment can be found at the right-hand side of the
machine, at the feed handles. Loosen the clamp and set the scale to
the desired position. The depth adjustment has two rings with cams.
These ensure that the spindle starts to run and comes back up when
the desired depth has been reached. Re-tighten the clamp.
Figure 3
6.3 s
peed
adjusTmenT
Figure 4
Pull the plug from the power supply!
1. Open the v-belt cover by turning the screw (A, fig. 4) and using the bracket to pull away the cover.
2. Loosen the nut at the backside of the motor (fig. 5).
3. Place the handle in the motor opening en push the motor forward (fig. 6).
4. Move the v-belt to the desired position.
5. Push the motor backwards again and unscrew the handle.
6. Close the v-belt cover and re-tighten the screw.
The belt tension is correct when you can push the belt in about 10 mm.
Figure 5
A
Figure 6
