HUSTLER Super Z HD, General Service Manual, Page: 44 / 50

REV C 8-2 117592
6.
Pump drive belt only - Inspect belt every 100 hours and replace if worn or cracking is noticed. Check spring tension adjustment. Otherwise, replace belt
every 400 hours or 2 years whichever comes first. Check and adjust spring tension after 50 hours of use as outlined in the Hydraulic Pump Belt Adjustment sec-
tion of the General Service Manual (117592).
7.
Check fuel system for any crack or leaks including, but not limit to, fuel line hoses, fuel valve, vent line hoses, vent valve, vapor valve, carbon canister, and
grommets. Repair as needed.
8.
More often under dusty or dirty conditions and during hot weather.
9.
Inspect ROPS after the first 20 hours of operation and then after every 500 hours of operation or yearly whichever comes first.
REFERENCES:
A. Refer to engine owner’s manual for engine service information.
NOTE: After completing maintenance cycle (500 hours), repeat cycle.
Maintenance Locator Chart
1. Engine Oil Fill & Dipstick
2. Fuel Filter
3. Engine Air Cleaner
4. Engine Oil Drain Plug
5. Battery
6. Fuel Tanks
7. Hydraulic Oil Reservoir
8. Hydraulic Oil Filter
9. Front Wheel Bearing Zerks (2)
10. Engine Oil Filter
11. Deck Height Pivot Zerks (4)
12. Park Brake Switch
13. Drive Tires
14. Pump Idler Zerk (1)
15. Pump Belt
16. Deck Pusher Arm Zerks (2)
17. Deck Belt
18. Spindle Housing Zerk (3)
19. Blades
20. Fuel Evaporation System Filter
21. Hydraulic Oil Heat Exchanger
22. Carbon canister
Figure 8-1
Figure 8-2 Figure 8-3 Figure 8-4
1
3
4
5
6
6
7
11
10
9
12
9
11
12
2
11
11
13
13
21
14
15
8
20
20
Carbon canister equipped machines
22
22