SGN141S-1 R290 Self-Contained Low Height Open Refrigerated Display Cabinet
Manual
Ju
ly
2021 Final Rev: 30A01
6
Equipment Required:
1 x Suitably sized Pallet Truck or Fork hoist.
NOTE: - the SGN141S-1 cabinet is fitted with castors
for final positioning, please take care as
wheels can be difficult to steer and/or may run freely on slight gradients. This is a minimum 2-
person task.
Once cabinets have been moved into the store with the shipping pallets** still attached, the
following methods should be used to move cabinets to their final installed position:
1. Carefully lift the cabinet off the pallet with a fork hoist or pallet truck, taking care to
position the forks in the centre of the cabinet and directly under the skid rails. Test for
stability / centre-of-gravity balance before making final movements.
2. Ensure the mounting feet bolts are screwed-up, such that the wheels can be utilised
when cabinet is lowered to the floor. Gently lower the cabinet on to the shop floor.
3. Ensure the floor where the cabinet is to be manoeuvred, is swept and free from debris,
as this could otherwise result in a roller wheel coming to an abrupt stop and destabilise
the cabinet.
4.
Once cabinet is in the required position, screw all four (4) feet bolts down into position
evenly such that all four (4) feet bolts take the full load of the cabinet and the roller
wheels have between
5mm ~ 10mm free space from the floor.
5. Ensure the cabinet is securely positioned and levelled via a spirit / laser / or theodolite
level.
6.
These Cabinets draw store
ambient air in through the Condenser coil located at the
bottom of the cabinet. Do not block either air entry or exit areas of the cabinet. NOTE: -
the top air exit should have at least a 1.0m clear area and height above the cabinet to
allow correct airflow and dissipation.
7. If the cabinet has been tilted during positioning/installation, wait at least three (3)
hours before starting in order to allow any potential oil displacement to settle.
Moving Cabinets to Installed Position
To ensure any risk of damage to cabinets while moving to their installed
location is minimised, it is strongly recommended that the following
instructions are followed.
**Timber (pallet only) and plywood (box only)
used for shipping materials and they are heat
treated (pallet only) and can be recycled
