1-4
INSTALLATION
3. Starting at the left end of the line up, install the
upper bumper starter section first. To install,
a. Position internal joint trims so that the first
is flush to the left-end panel and the second
is centered between the starter bumper and
the full length bumper as shown below.
b. Install full length bumpers
and internal trims offset
across joints. Make sure that
no gaps exist between sec-
tions. Continue installing
the upper bumpers the
length of the line up. Do
NOT install the last upper
bumper section at this time.
This section will be installed
in the last step.
4. Install lower bumper starter and
full length lower bumpers by
simply pushing them into place.
Start at the right end of the line-
up for additional camouflage.
There are no internal joint trims
on the lower bumpers.
P/N 0416183C
Splashguard
in place
Starter
Bumper
Internal
Joint Trims
Full
Length
Bumper
Starter
Bumper
Lower
Bumper
Starter
Bumper at
Right End
Upper
Bumper
Full
Length
Bumper
