P/N 558756_C
U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com
2
LOCATION
EcoVision EZ doors are designed for merchandis-
ers that display products in air conditioned stores
where temperature is maintained at or below
75°F (24°C) and relative humidity is maintained
below 55%. Fogging, moisture and corrosion may
occur on the doors if merchandisers are operat-
ed outside these conditions.
Placing refrigerated merchandisers in direct
sunlight, near hot tables or near other heat
sources could impair their efficiency, which may
cause the doors to fog. Refrigerated cases are
sensitive to air disturbances. Air currents passing
around merchandisers will seriously impair
their operation. Do NOT allow air conditioning,
electric fans, open doors or windows, etc. to
create air currents around the merchandisers.
Product should always be maintained at proper
temperature. This means that from the time the
product is received, through storage, preparation
and display, the temperature of the product must
be controlled to maximize product life.
CASE LEVELING
Merchandisers must be installed level to ensure
proper operation of the refrigeration system
and to ensure proper drainage of defrost water.
In order for the gravity hinge self-closing doors
to close properly, the merchandisers must be
leveled correctly. Do not attempt to install
the doors or make glass adjustments prior to
ensuring the cases are level.
Shims are provided with each door kit. Use
provided metal shims.
Prepare Merchandiser(s) for Doors:
1
Carefully unpack EcoVision EZ Door
upgrade kit(s), and examine parts. Do
not carry doors by the handle.
2
Carefully remove canopy fascia(s)
from the merchandiser(s).
A.
Remove screws from fascia. Unhook the
canopy fascia panel by lifting out from
the center at the bottom as shown in
Figure 2-1.
B.
Remove canopy fascia. Canopy fascia
will be reinstalled later
C.
Loosen rods in canopy between the
joined cases as shown in Figure 2-2.
Flat Washer
Hex Nut
Threaded
Rod
Loosen Canopies
of Multi-deck Wall Cases
Figure 2-2 — Loosen Canopy Screws
between cases
Fascia
Figure 2-1 — Canopy Fascia
