P/N 558756_C
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
15
EcoVision EZ Door Upgrade
19
Install EcoVision EZ Door(s) and top
bushings.
A.
Insert top of door into bushing hole of door
as shown in Fig. 19-1.
B.
Raise door up and position gravity hinge at
the bottom of the door into bottom hinge plate
cross hole as shown in Fig. 19-2.
C.
Install remaining doors.
IMPORTANT - AFTER DOORS ARE INSTALLED!
Remove the tag from the door, pulling the C-Clip
from the gravity hinge.
Figure 19-1
Remove the clip by pulling the tag, and
the door will close.
Seating factory supplied door
Downward pressure should
fully seat the door. If not,
the door must be opened or
closed slightly to align the
cross feature.
The cross will align when the
door is opened slightly. The
door will not seat if not
aligned properly. Do not
leave the door unseated.
Do not carry doors by handle.
Personal injury and damage to
the doors may result.
Figure 19-2
Bottom of Gravity Hinge
“L” marked for LEFT
door
