P/N 558756_C
U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com
14
17
Fasten left and right end mullions using
#8 and #10 -16 x 1 in. hex head screws.
18
Install bottom hinge plate assembly into
the bottom rail extrusion about a
1
/
4
in.
from end of extrusion. (3) plates for
12-ft case, (2) plates for 8 ft. case. There
is a an “L” stamped on the left side and
an “R” on the right side.
A.
Insert one screw into the center hole and
only the center hole. Do not tighten com-
pletely. This will allow for leveling of the
doors later.
Move plate in
1
/
4
inch from end
Figure 17-2
Figure 17-1
Figure 18-1
NOTE:
End mullions may be used on the left, or the right side of merchandiser. If LEDs are
installed, mullions with LEDs are marked (L) left, (R) right), (C) center.
Bottom Rail Alignment Plate
use on case joints
Arrow on hinge plate must face inside of case as
shown. If the arrow is installed on the outside
the doors will not close.
