4-2
s
taRt
up
/ o
peRatIon
P/N 0501930_G
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • www.hussmann.com
MULTI-DECK SHELF ALIGNMENT
Taped to one of the shelves of each
merchandiser is a small plastic bag containing
shelf alignment strips . These strips are
designed to enhance the appearance of the
shelves by aligning the front edge of each shelf
with that of an adjacent shelf .
When installing shelves:
1 . Insert one of the alignment strips into the
slot behind the front edge of each shelf .
2 . After all shelves are installed, slide the strip
across the shelf joint wherever two shelves
are adjacent . This will lock them together .
MULTI-DECK SHELF CONFIGURATION
Shelves are individually mounted in 1 in .
(25 mm) increments and have two-, three-,
or four-position brackets permitting shelves
to be placed in a flat or down-tilt position
(see illustration) . Front product stops are
recommended when shelves are placed in the
down-tilt position .
Case performance will be degraded if peg
shelves are used without baffles . Unauthorized
specialty shelving may cause poor merchan-
diser performance also . Consult your
Hussmann representative to ensure optimum
performance of Hussmann equipment . Note
that lighted shelves cannot be used in rear
load merchandisers .
INSTALLING FDA/NSF REQUIRED
THERMOMETER
The following pages provide the same
information that ships with the thermometer .
This requirement does not apply to display
refrigerators intended for bulk produce
(refer to
page 1-1) .
Please note that the tape cannot be exposed
after installation .
Shelf Alignment Strip
(
5
/
8
x 6 in. — 16 x 152 mm)
Posición 2 Posición 3 Posición 4
