English
– 13
STARTING AND STOPPING
Before starting
•
Enclose the area to be cut so that unauthorised persons
can not be injured or disturb the operator.
•
Check that the blade and th blade guard is not damaged
or cracked. Replace the blade or the blade guard if it is
exposed to impact or is cracked.
•
Make sure that all hydraulic hoses and connections are
intact and correctly connected, and that the water cooling
is correctly connected and switched on.
•
Check the oil level in the cutting unit. Adjust the speed
valve on the saw motor to the correct position, depending
on the blade diameter. (See the Cutting capacity table).
•
If cutting is to begin in another position than where the
saw unit is located, run the saw unit to the start position.
Starting
Follow the instructions for starting in the manual supplied with
the hydraulic unit.
Stopping
•
Once cutting is completed, remove the blade from the wall
and shut down the blade rotation and the water flow.
•
Shut down the hydraulic unit.
Dismantling the saw
1
Allow the motor to stop completely.
2
Disconnect the incomming cables from the hydraulic unit.
3
Switch off the power to the hydraulic unit.
4
Disconnect the hydraulic hoses and the water hose from
the saw unit.
The other steps are done in the reverse order to assembling.
Cleaning
The saw should be cleaned once cutting is finished. It is
important to clean all the saw equipment. It is a good idea to
disconnect the water hose from the pivot arm and use this to
wash down the saw unit, rail, blade guard, wall mounting. If
necessary you can also use a dish-brush or the like to clean
the equipment. Do not use a high pressure washer to clean
the saw.
IMPORTANT! Do not use a high pressure washer to clean
the saw.
