12 –
English
ASSEMBLY
Fit the blade guard
1
Slip in the blade guard guide between the stays on the
blade guard. Place the blade guard guide in the middle.
Lock the plastic heel on the handle to the upper stay on
the blade guard.
2
Make sure that the pivot arm is positioned vertically. Lift
the blade guard over the blade and hang the guard in the
blade guard holder on the saw. Exercise care so that the
runners on the blade guard are positioned in the slots on
the water block.
3
Lock the blade guard by pulling the handle out of the
guard and then down towards the saw unit so that the
latch locks the handle.
4
To remove the guard, release the latch and pull the handle
upwards and inwards to the guard. Lock the plastic heel
on the upper stay.
Connect the hydraulic unit
Please read the operator´s manual supplied with the
hydraulic unit before using the machine.
When the saw unit, the blade and the blade guard are
mounted, the hydraulic hoses and the water cooling should
be connected.
There are two types of hydraulic hoses for the saw:
•
The four thin hoses control the feed motors, i.e. the saw’s
travel feed on the rail and the feed - removal of the blade.
The two thick hoses drive the blade.
•
The couplings should be wiped clean to reduce the risk of
leakage before the hoses are fitted. Both the thin and thick
hoses are locked by turning the outer sleeve on the female
coupling so that the groove in the sleeve moves away from
the ball.
!
WARNING! Never mount or dismount the
blade or blade guard without first switching
off the hydraulic unit and disconnecting the
hydraulic hoses running to the saw unit.
Carelessness can result in serious personal
injury or even death.
IMPORTANT! This machine is only intended for use
together with a Husqvarna PP 345 and Husqvarna RC 348.
All other use is forbidden.
