Standard Operating Procedure
HUSQVARNA TILE SAW 9” TS73R
Version 3 Issue date: 6/05/2017
Page 4 of 4
20 Goodshed Road Upper Hutt
Phone 04 528 4473
Section 9: Transport
1. Unplug the machine
2. Lock the head on the rear part of the saw, using clip ‘A”, so that the head is secured.
3. Loosen the two flywheels (B) of the front legs, and swivel them to a horizontal position,
then retighten the flywheels.
4. Repeat the same procedure for the back legs.
5. To reinstall the machine on its legs, carry out the above procedure in reverse.
Section 10: Additional Information
Always use common sense! It is not possible to cover every conceivable situation you can face when using our equipment. Always
exercise care and use your common sense. Avoid all situations which you consider to be beyond your capability. If you still feel
uncertain about operating procedures after reading these instructions and the owner’s manual, you should consult an expert before
continuing. The information contained herein is true and accurate to the best of our knowledge. No warranty or guarantee is
expressed or implied regarding the accuracy of information or instructions. Users MUST consult the manufacturer’s manual or
handbook. While every effort has been made to summarise the important Health and Safety information for the safe use of this
equipment, Upper Hutt Hire Ltd shall not be liable in any way for any reliance by any person or entity on the accuracy of information
or data contained in this document or its attachments.
Revision date
May 2022 (SOP based on
Husqvarna Manual TS73R 115 03 00-20 2007-03-15)
