19
OPERATION
Cutting with the Cutting Head locked down
•
Locked Cutting Head setup: Lock the Trigger
Switch (D8). Hold work in position.
•
Slowly push the Casting Table (F1) towards the
Blade (H8) to begin cutting.
•
Continue to push work into the Blade (H8) until
the cut is complete. Unlock the Trigger Switch (D8).
Allow the Blade (H8) to stop moving before
removing the work.
NOTICE
This method is preferred when cutting small objects.
•
Align holes on the Pivot Clamp (C1). Insert the
Pivot Pin (C4) to lock the Cutting Head in the down
position.
C1
•
When the cut is complete, hold the Handle (D1) in
the down position. Remove the Pivot Pin (C4) to
release the Cutting Head.
D8
Work
H8
F1
H8
D8
D1
C4
