Husqvarna TS 350E, Operator'S Manual

Page: 7 / 16

Any persons not involved in the work should
leave the working area.
Use blades suitable for the work to be done
(speed, geometry, application, etc.).
Fitting the disc
Disconnect the machine by unplugging the sup-
ply cable.
• Remove the two screw knobs (A) and the protective
case (B) (See fi g. 9).
The disc locking nut has a left-hand thread.
If the machine is fi tted with a brake motor, do
not use the quick-tightening nut.
• Remove the locking fl ange (See fi g. 10).
• Fit the disc (See fi g. 11).
Take care about the direction of rotation
which is shown by an arrow on one of the
faces.
Make sure the contact faces of fl anges, of
blade and the axle are clean.
• Tighten the nut (1) and lock (2)
• Re fi t the protective case (B).
• Tighten the 2 screw knobs (A) (See fi g. 13).
Electrical connection
Electrical safety
Operate this machine only on a supply equipped
with a 30 mA earthed current-limiting circuit-
breaker. Otherwise, consult our catalogue for
appropriate models.
The RCCB must be used correctly, including
testing it regularly. For tools supplied with an
integral RCCB in the cable or in the mains plug,
if the cable or plug has been damaged, repairs
must be carried out by the manufacturer, one of
his agents or by a quali
fi ed repair workshop to
avoid any risks resulting from errors.
Make sure that the mains voltage corresponds
with that marked on the manufacturer’s plate
on the machine.
Three-phase motor Make sure that the mo-
tor rotates in the same direction as the arrow
stamped on the casing: if the motor does not
turn in the direction required, swap two of the
supply wires.
Operator’s manual - TS 350 E
T
Use the following types of plug, single phase 2
P + E, or 3xPx+xE / 3xPx+xNx+xE according to
the corresponding voltage.
- Extension lead: Cable size suf fi cient for the electrical
power, connection to the mains by a H07 RNF type cable
of the following size:
• 3 x 2.5 mm2 up to 50 m for 230 V
• 4 or 5 x 1.5 mm2 up to 100 m for 400 V
• 3 x 4 mm2 up to 40 m for 115 V
Starting up
Always pay extreme care and attention to the
preparation of the machine before starting
up
Remove all adjustment tools and wrenches
from fl oor and machine
Always keep blade guard in place
• Fill the water tank ( Level 23. See fi g. 1 ).
• The water pump starting is coupled with that of the
motor.
As each machine is fi tted with a self priming pump, the
water is sprayed onto the disc as soon as the machine
starts.
Ensure that the water supply is abundant, when cut-
ting wet.
The protective case and the motor mounting fi tted
with a defl ector blade provide perfect distribution of
the spray.
• To start the machine press the green button
on the switch (optional cut-out switch).
• To stop the machine, press the red button.
One-phase motor protected by a built-in thermal cir-
cuit breaker.
!
!
?
=
STOP
Polish -
7