Husqvarna TS 300 E, User'S And Operator'S Manual

Page: 6 / 56

Note: Setting the TS 300 E for a 350 Ø disk
(Factory setting is 300 Ø)
Warning: the setting procedure described is for an uninstalled disk.
1- Slide the cables through the plastic collar attached to the arm
of the TS 300E. Be careful to keep electric cables and water
hose clear of the setting screw located at the back. 2- Remove the nut and washer with the 30 mm wrench (UK
spanner) provided.
3- Tilt the head of the machine to clear the centering pin. 4- Remove the head by pulling it toward the front to clear the
axis of the head from the lower arm hole of the TS300E.
5- Insert the head spindle into upper hole of the TS 300E. 6-Insert the centering pin into the housing. Hold the head
horizontally and put back the washer and nut with the 30 mm
wrench (UK spanner)
Warning: always check that the head spindle is inserted into the right hole
for the disk used
(lower hole for 300 Ø; upper hole for 350 Ø).
Please make sure that the electric cables do not get pinched or caught.