Husqvarna TS 250 XL, Operator'S Manual

Page: 2 / 22

NOTE:
Part Numbers that have an ASTERISK (*) suffix may not be active 9-digit
numbers. The ‘542’ prefix have been added to current 6-digit part numbers and
‘0’ to 8-digit part numbers.
EVERY MACHINE IS THOROUGHLY TESTED BEFORE LEAVING THE FACTORY. EACH MACHINE IS SUPPLIED
WITH A COPY OF THIS MANUAL. OPERATORS OF THIS EQUIPMENT MUST READ AND BE FAMILIAR WITH THE
SAFETY WARNINGS. FAILURE TO OBEY WARNINGS MAY RESULT IN INJURY OR DEATH. FOLLOW INSTRUC-
TIONS STRICTLY TO ENSURE LONG SERVICE IN NORMAL OPERATION.
CONTENTS
Symbol Definitions ....................................................................................................................................................3.-.5
Hearing Hazard Warning ............................................................................................................................................... 5
Dust Warning ................................................................................................................................................................. 6
Decal Descriptions and Locations ............................................................................................................................6.-.7
Safety Warnings - DOs & DO NOTs .........................................................................................................................8.-.9
Figures:
Figure 1 ....................................................................................................................................................................... 10
Figure 2 ....................................................................................................................................................................... 10
Figure 3 ....................................................................................................................................................................... 14
Figure 4 ....................................................................................................................................................................... 16
Instructions:
1. Features ............................................................................................................................................................. 11
2. Benefits .............................................................................................................................................................. 11
3. Machine Set-Up .......................................................................................................................................... 11 - 13
4. Operating Procedure ......................................................................................................................................... 13
5. Adjustable Lockbar With Depth Linking Protection ............................................................................................ 14
6. Manual Thermal Overload ................................................................................................................................. 14
7. Recommended Extension Cords ....................................................................................................................... 14
8. Alignment Procedures ................................................................................................................................ 14 - 15
9. Profile Wheel Set-Up and Use ........................................................................................................................... 15
10. Plunge Cutting ................................................................................................................................................... 15
11. Maintenance Procedures ................................................................................................................................... 15
12. Water Pump, Trouble Shooting Procedure ........................................................................................................ 16
13. Repairs & V-Belt Tensioning with Cam Adjustment ........................................................................................... 16
14. Spare Parts ........................................................................................................................................................ 16
15. Tile Cutting Accessories ..................................................................................................................................... 17
Wiring Diagrams ................................................................................................................................................... 18 - 19
Warranty ...................................................................................................................................................................... 21