5
UNASSEMBLED PARTS
Washer
Hex Bolt
Seat
Steering Wheel
Steering
Wheel Adapter
Steering
Boot
Washer
Insert
Hex Bolt
Lock Washer
Steering
Extension
Shaft
Hoodscoop
Steering
Seat
Key(s)
Slope Sheet
(1) Hood Scoop
Fig. 1
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to ensure proper tightness.
TO CHECK BATTERY (See Fig. 1)
• Lift seat to raised position.
NOTE:
If this battery is put into service after month and
year indicated on label (label is located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in Maintenance section of this manual
for charging instructions).
• For battery and battery cable installation see "RE-
PLACING BATTERY" in the "Service and Adjustments"
section in this manual.
LABEL
ASSEMBLY
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton .
• Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels flat.
• Check for any additional loose parts or cartons and
remove.
BEFORE REMOVING TRACTOR FROM
SKID
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(1) 5/16" wrench
Utility knife
(2) 7/16" wrenches
Tire pressure gauge
(2) 1/2" wrenches
Pliers
(1) 9/16" wrench
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).
