9. Technical specifications
The table below gives the technical specifications for the
FS800 E/EM floor saw. It is extremely important that you
check these before:
- Choosing a floor saw.
- Choosing and fitting a diamond blade.
- Connecting to the mains supply.
- Choosing a power cable.
- Choosing the cutting depth.
- Transporting the machine.
If you are unsure about the meaning of the technical specifica-
tions or ordering spare parts, please contact your supplier
FS800 E/EM ART. NOS. 50020 AND 50030
Motor rating
kw
7.5
Voltage and type of supply
V/phase/Hz
400/3/50 or
220/3/50
Power cable
REVE
5x2.5
Polarity
Europa plug
16 Amp.
Phase inverter
in socket
Drive shaft speed
rpm
1150
Max. peripheral speed.
m/s
63
Max. diamond blade diameter
mm
800
Parking brake
yes
Base plate
optional
accessory
Chain drive
optional
accessory
Max. Cutting depth
mm
320
Length approx.
mm
1500
Width approx.
mm
780
Height approx.
mm
1120
Weight (excl. blade) approx.
kg
220
Noise
noise power
<101.7
Lw rel. pw
according to ISO
744 dB(A)
Noise
noise pressure
<84.8
Lp rel. 0µPa at
ear during
operation B(A)
Vibration
according to.
0.8 m/s2 (H/A)
ISO 7505
10
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
FAULT
CAUSE
REMEDY
Blade turns wrong way.
Phases from power cable are inverted.
Change polarity using phase inverter.
Drive belt is slipping.
Belt is too slack.
Adjust belt tension.
Drive belt is worn.
Replace the drive belt.
Drive belt is oily.
Clean the drive belt.
Motor cuts out.
Cutting depth too large.
Reduce cutting depth.
Cutting speed too high.
Advance more slowly.
Diamond segments are worn.
Replace diamond blade.
Electrical fault.
Contact a qualified electrician.
No cooling water.
Nozzles are blocked.
Clean nozzles.
Water pressure low.
Blade gets jammed.
Blade is worn.
Replace blade.
Cut closing up.
Cut smaller sections, or
support from below using props or a jack.
Motor does not start.
Electrical fault.
Contact your electrician.
Emergency stop activated.
Determine cause. When fault is
fixed, pull up emergency stop.
NOTE! Do not start the machine before rectifying the cause of the fault.
