Husqvarna F2401V5, Owner'S Manual

Page: 21 / 152

CONTROLS 6
19
6.11 Closing 2-stroke oil tank cap
K01333-10
–
Put the 2-stroke oil tank cap on and turn it clockwise.
–
Fold loop
1
down.
The 2-stroke oil tank cap engages.
6.12 Cold start button
K01324-11
The cold start button
1
is fitted on the side of the throttle valve
body.
If the engine is cold and the ambient temperature is low, the
electronic fuel injection system extends the injection time. To
help the engine burn the increased fuel quantity, it must be sup-
plied with additional oxygen by pulling the cold start button.
Info
If the engine is warm, the cold start button must be deac-
tivated.
Possible states
• The cold start button is activated
–
The cold start button is
pulled out all the way and turned by a ¼ turn.
• The cold start button is deactivated
–
A further ¼ turn
returns the cold start button back to the basic position.
6.13 Idle speed adjusting screw
K01324-10
The idle setting of the throttle valve body substantially influences
the vehicle’s starting behavior, a stable idle speed, and the vehi-
cle’s response when the throttle is opened.
An engine with a correctly set idle speed is easier to start than an
engine with the idle speed set incorrectly.
The idle speed is adjusted using the idle speed adjusting
screw
1
.
Info
If the idle speed is high, the engine is slow to run, the
engine brake is low and the throttle response is aggres-
sive, the adjustment screw must be turned clockwise.
If the idle speed is low, the engine is running fast,
the engine brake is high and the throttle response
is not clean, the adjusting screw must be turned
counterclockwise.