Husqvarna F1303V1, Owner'S Manual

Page: 118 / 140

21 TROUBLESHOOTING
116
Faults Possible cause Action
The engine does not turn when
the start button is pressed
Operating error
–
Carry out start procedure. ( p. 38)
12-V battery discharged
–
Charge the 12-V battery. ( p. 90)
Main fuse or fuse
3
,
4
or
7
blown
–
Change the main fuse. ( p. 93)
–
Change the fuses of individual electri-
cal power consumers. ( p. 95)
No ground connection present
–
Check the ground connection.
Engine turns only if the clutch
lever is drawn
The vehicle is in gear
–
Shift the transmission into neutral.
The vehicle is in gear and the
side stand is folded out
–
Shift the transmission into neutral.
Engine turns but does not start Operating error
–
Carry out start procedure. ( p. 38)
Malfunction in the electronic
fuel injection
–
Read out the fault memory using the
Husqvarna Motorcycles diagnostics
tool.
Engine has too little power Air filter is very dirty
–
Change the air filter.
Fuel filter is very dirty
–
Check the fuel pressure.
Malfunction in the electronic
fuel injection
–
Read out the fault memory using the
Husqvarna Motorcycles diagnostics
tool.
Engine overheats Too little coolant in cooling
system
–
Check the cooling system for leakage.
–
Check the coolant level. ( p. 100)
Radiator fins very dirty
–
Clean the radiator fins.
Foam formation in cooling sys-
tem
–
Drain the coolant. ( p. 101)
–
Fill/bleed the cooling system.
( p. 102)
Thermostat defective
–
Check the thermostat.
Fuse 5 blown
–
Change the fuses of individual electri-
cal power consumers. ( p. 95)
Defect in radiator fan system
–
Check the radiator fan system.
Malfunction indicator lamp
lights up yellow
Malfunction in the electronic
fuel injection
–
Read out the fault memory using the
Husqvarna Motorcycles diagnostics
tool.
Engine dies during the trip Lack of fuel
–
Refuel. ( p. 46)
Main fuse or fuse 3 , 4 or 7
blown
–
Change the main fuse. ( p. 93)
–
Change the fuses of individual electri-
cal power consumers. ( p. 95)
ABS warning lamp lights up ABS fuse blown
–
Change the ABS fuses. ( p. 94)
Large difference in wheel
speeds of the front and rear
wheels
–
Stop the vehicle, switch off the igni-
tion, and start it again.
Malfunction in ABS
–
Read out the fault memory using the
Husqvarna Motorcycles diagnostics
tool.
High oil consumption Engine vent hose bent
–
Route the vent hose without bends or
change it if necessary.
Engine oil level too high
–
Check the engine oil level. ( p. 108)
Engine oil too thin (low viscosi-
ty)
–
Change the engine oil and the oil filter,
clean the oil screens. ( p. 108)
Headlight and position light are
not functioning
Fuse 6 blown
–
Change the fuses of individual electri-
cal power consumers. ( p. 95)