Husqvarna F1303V1, Owner'S Manual

Page: 102 / 140

16 COOLING SYSTEM
100
E01306-10
Main work
–
Stand the motorcycle upright on a horizontal surface.
–
Remove cap
1
of the compensating tank.
–
Check the antifreeze in the coolant.
−
25 …
−
45 °C (
−
13 …
−
49 °F)
» If the antifreeze in the coolant does not match the speci-
fied value:
–
Correct the antifreeze in the coolant.
–
Check the coolant level in the compensating tank.
The coolant level must be between MIN and MAX .
» If the coolant level does not match the specified value:
–
Correct the coolant level.
Coolant ( p. 128)
–
Mount the cap of the compensating tank.
E01305-10
–
Remove radiator cap
2
.
–
Check the antifreeze in the coolant.
−
25 …
−
45 °C (
−
13 …
−
49 °F)
» If the antifreeze in the coolant does not match the speci-
fied value:
–
Correct the antifreeze in the coolant.
–
Check the coolant level in the radiator.
The radiator must be filled completely.
» If the coolant level does not match the specified value:
–
Check the coolant level and the reason for the loss.
Coolant ( p. 128)
» If you had to add more coolant than the specified
amount:
> 0.20 l (> 0.21 qt.)
–
Fill/bleed the cooling system. ( p. 102)
–
Mount the radiator cap.
Finishing work
–
Install the right side cover. ( p. 59)
–
Mount the seat. ( p. 55)
16.3 Checking the coolant level
Warning
Danger of scalding
During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not open the radiator, the radiator hoses or other cooling system components if the engine or
the cooling system are at operating temperature.
–
Allow the cooling system and the engine to cool down before you open the radiator, the radiator
hoses or other components of the cooling system.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.