Husqvarna CL400, Operator'S Manual

Page: 13 / 380

Problem Cause
The engine does not start There is no fuel in the fuel tank.
The fuel tap is closed.
When the engine is cold, the gas lever is not moved to START position.
When the engine gets warm, the gas lever is moved START position.
The gas lever is moved to STOP position.
The fuel does not reach the carburettor.
The air filter is clogged.
The vent hole on the fuel cap is closed by impurities.
The spark plug is defective.
The cutter does not rotate even if the
related lever is engaged
The belt is worn out.
The belt has slipped out of the pulleys.
The lever does not stretch the belt properly.
The cutter continues to rotate when
the lever is disengaged
The brake pulley is not engaged.
The brake lining does not rest on the pulley side.
The brake lining is consumed.
The product does not opearate cor-
rectly
The cutter is too worn.
The cutter is broken or not installed.
The air filter is clogged. In this case, blow the air filter with compressed air or
replace it with a new one.
The fuel is insufficient.
The engine oil level is lower than the minimum limit.
The product does not move when the
forward lever is engaged
The cable is slackened.
The transmission belts are worn.
The chain is broken or slacken.
The clutch discs inside the transmission housing are worn.
it is to hard to steer the product The handlebar is slacken.
The head of the cutter does not slide,
preventing the replacement of the
cutter
There are residues in the unit.
There is oxide formed inside the system.
The insulation of the cable laid down
is damaged
The outlet spout of the cable on the blade is damaged.
The tube that contains the cable and which is part of the blade is dirty.
1394 - 002 - 27.11.2019 13