Husqvarna 550H EPOS, Operator'S Manual, Page: 17 / 44

Note:
It is only necessary to pair the Automower ®
Connect app and the product one time.
3.8.8 Installation of the map
On the map you can install the objects that follow in the
Automower
®
Connect app:
•
Work areas
(A)
• Stay-out zones (B)
• Transport path (C)
• Charging station (D)
•
Point of interest
(E)
•
Work area, Secondary area
(G)
A
G
B
A
F
D
E
C
Read and understand the instructions about where to
install the map objects. Refer to
To examine where to
install the objects on the map on page 14 .
For a complete map installation a work area and a
charging station are necessary.
A work area is an area where the product can operate
and cut grass automatically. A work area is specified by
virtual boundaries. The charging station can be put in
the work area or near the work area that is connected to
it with a transport path. A work area with no charging
station in the work area and no charging station
connected to it with a transport path is operated as a
secondary area. Maximum 20 work areas can be
installed on a map.
A transport path is a specified path between the docking
point in front of the charging station and a work area.
The product can operate automatically in this path, but
does not cut grass. A transport path can temporarily be
enabled and disabled in the app.
Stay-out zones can be made if there are areas where
the product must not operate. A stay-out zone is
specified by virtual boundaries. Stay-out zones can
temporarily be enabled and disabled in the app.
A point of interest is a specified position where the
product can be parked at. This can for example be used
for a service point where maintenance of the product is
done. The point of interest is connected to the docking
point with a path.
To install objects on the map, operate the product with
the appDrive installation to add waypoints on the map.
The status EPOS confirmed is necessary to add
waypoints on the map. The waypoints (A) are positions
that specifies the virtual boundaries and paths (B). The
lines are straight between the waypoints. Add a number
of waypoints to make smooth curves. Minimum 3
waypoints are necessary to make a work area or a stay-
out zone. You can adjust the positions of the waypoints
in the app after the installation of the map.
B
A
CAUTION:
Do not lift and move the
product between the waypoints during the
installation. Use appDrive for a correct
installation.
1619 - 002 - 19.01.2021 Installation - 17