ASSEMBLY
English
–
13
Assembling the handlebar and
throttle
CAUTION! Some models have the throttle handle fitted at
the factory.
•
Remove the screw at the rear of the throttle handle.
•
Slide the throttle handle onto the right side of the
handlebar, (see diagram).
•
Align the screw hole in the throttle handle with the hole
in the handlebar.
•
Refit the screw in the hole in the rear of the throttle
handle.
•
Screw the screw through the handle and handlebar.
Tighten it.
•
Unscrew the knob from the handlebar mounting.
•
Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
•
Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that the
machine is in a comfortable working position when it
hangs from the harness.
•
Tighten the knob.
Transport position, handlebar
•
The handlebar can easily be turned to fit along the
shaft for easier transportation and storage.
•
Loosen the knob. Turn the handlebar clockwise so that
the throttle handle rests against the engine.
•
Now twist the handlebar around the shaft. Tighten the
knob.
•
Fit the transport guard to the cutting attachment.
Assembling the cutting
equipment
Always wear approved protective gloves.
545 FR
545 FX , 545 FXT
545 RX, 545 RXT
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
!
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
IMPORTANT! If a saw blade or grass blade are to be
used the machine must be equipped with the correct
handlebar, blade guard and harness.
