MAINTENANCE
24
1740274
HOW TO REPLACE THE AUGER
1. Remove the belt cover. See “How To Remove The Belt
Cover”.
2. Remove the drive belt. See “How To Replace The Drive
Belt”.
3. Use a 1-inch wrench and remove the
auger pulley
from the auger shaft (threads are left hand; turn clock-
wise to remove). (See Figure 22).
4. To keep the
auger
from rotating, set a 2”x4” piece of
wood
on the center
paddle
to secure
auger
.
5. Use a 7/16-inch wrench and remove the fasteners from
the
bearing assembly
. Remove the
bearing assem-
bly
from the
auger housing.
6. Slide the
auger
out of the bearing assembly on the
right side of the snow thrower.
7. Tip the
auger
enough to allow the
auger
to slide out of
the
auger housing.
8. To install
auger,
reverse the above steps.
Figure 22
Bearing Assemlby
Auger Pulley
Auger Housing
Auger
Center Paddle
Wood
Summary of Contents for 521SSE
Page 28: ......
