Husqvarna 340i, Operator'S Manual

Page: 14 / 120

10. Tighten the bar knob.
To assemble the guide bar and saw
chain (with bar bolt)
WARNING:
Always remove the battery
before you assemble or do maintenance on
the product.
1. Disengage the chain brake.
2. Loosen the bar nut and remove the drive sprocket
cover and the transportation ring (A).
A
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw
chain above the drive sprocket and engage it in the
groove on the guide bar. Start on the top edge of
the guide bar.
4. Make sure that the edges of the cutters point
forward on the top edge of the guide bar.
5. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
6. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
7. Make sure that the saw chain is correctly engaged
in the groove in the guide bar.
8. Tighten the bar nut with your fingers.
9. Tighten the saw chain. Refer to
Maintenance on
page 24
for instructions.
Operation
Introduction
WARNING:
Read and understand the
safety chapter before you use the product.
To do a function check before you use
the product
1. Do a check of the chain brake (A) to make sure
that it operates correctly and that it is not damaged.
2. Do a check of the rear right hand guard (B) to
make sure that it is not damaged.
3. Do a check of the power trigger and the power
trigger lockout (C) to make sure that they operate
correctly and that they are not damaged.
4. Do a check of the keypad (D) to make sure that it
operates correctly.
5. Make sure that there is no oil on the handles (E).
6. Do a check to make sure that all parts are correctly
attached and not damaged or missing.
7. Do a check of the chain catcher (F) to make sure
that it is attached correctly.
8. Do a check of the chain tension (G).
9. Charge the battery (H) and make sure that it is
correctly attached to the product.
14 1155 - 005 - 29.06.2020