Husqvarna 2014 TE 125 EU, Owner'S Manual

Page: 50 / 128

12 SERVICE WORK ON THE CHASSIS
48
L01627-10
–
Mount and tighten screw
8
.
Guideline
Screw, top steering stem M8 17 Nm
(12.5 lbf ft)
Loctite ® 243™
L01670-11
–
Tighten screws
9
.
Guideline
Screw, top triple clamp M8 17 Nm (12.5 lbf ft)
C00578-11
–
Position the brake caliper. Mount and tighten screws
bk
.
Guideline
Screw, front brake caliper M8 25 Nm
(18.4 lbf ft)
Loctite ® 243™
–
Mount cable binder
bl
.
–
Position the brake line, wiring harness, and clamp. Mount and tighten screws
bm
.
–
Install the front fender. ( p. 50)
–
Install the headlight mask with the headlight. ( p. 83)
–
Install the front wheel.
x
( p. 75)
Finishing work
–
Check that the wiring harness, throttle cables, and brake and clutch lines can move
freely and are routed correctly.
–
Check the play of the steering head bearing. ( p. 48)
–
Remove the motorcycle from the lift stand. ( p. 43)
12.13 Checking the play of the steering head bearing
Warning
Danger of accidents Unstable vehicle handling from incorrect steering head bearing play.
–
Adjust the steering head bearing play without delay. (Your authorized Husqvarna workshop will be glad to help.)
Info
If the bike is ridden with play in the steering head bearing, the bearing, and the bearing seats in the frame can become damaged
over time.
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 43)
400738-11
Main work
–
Move the handlebar to the straight-ahead position. Move the fork legs to and fro in
the direction of travel.
No play should be noticeable in the steering head bearing.
» If there is noticeable play present:
–
Adjust the play of the steering head bearing.
x
( p. 49)
–
Move the handlebar to and fro over the entire steering range.
The handlebar must be able to move easily over the entire steering range. There
should be no perceptible detent positions.