Husqvarna 2014 TE 125 EU, Owner'S Manual

Page: 51 / 128

12 SERVICE WORK ON THE CHASSIS
49
» If detent positions are noticeable:
–
Adjust the play of the steering head bearing.
x
( p. 49)
–
Check the steering head bearing and change if necessary.
Finishing work
–
Remove the motorcycle from the lift stand. ( p. 43)
12.14 Adjusting the play of the steering head bearing
x
Preparatory work
–
Raise the motorcycle with the lift stand. ( p. 43)
L01629-10
Main work
–
Loosen screws
1
. Remove screw
2
.
–
Loosen and retighten screw
3
.
Guideline
Screw, top steering head M20x1.5 12 Nm (8.9 lbf ft)
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Tighten screws
1
.
Guideline
Screw, top triple clamp M8 17 Nm (12.5 lbf ft)
–
Mount and tighten screw
2
.
Guideline
Screw, top steering stem M8 17 Nm
(12.5 lbf ft)
Loctite ® 243™
Finishing work
–
Check the play of the steering head bearing. ( p. 48)
–
Remove the motorcycle from the lift stand. ( p. 43)
12.15 Greasing the steering head bearing
x
800010-10
–
Remove the lower triple clamp.
x
( p. 46)
–
Install the lower triple clamp. x ( p. 47)
12.16 Removing the front fender
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the headlight mask with the headlight. ( p. 82)
C00596-10
Main work
–
Disconnect plug-in connectors
1
of the turn signals.
–
Remove screws
2
.
–
Take the brake line and wiring harness out of the brake line guide.