Husqvarna 2011 SMS 125, Workshop Manual

Page: 38 / 244

D.12
H02651
1
MIN
H02694
2
a
1
SETTINGS AND ADJUSTMENTS
Ed. 05-2011
Rear brake fluid level check
Master cylinder fluid level - visible through sight glass (1) - must be above the
minimum notch on master cylinder reservoir.
A decrease of the fluid level will let air into the system, hence an extension of
the lever stroke.
If the brake pedal feels mushy when pulled, there may be air in the
brake lines or the brake may be defective.
Check the system or proceed to drainage as outlined in the relevant
paragraph.
Do not spill brake fluid onto any painted surface or light lens.
Do not mix two brands of fluid. Completely change the brake fluid
in the brake system if you wish to switch to another fluid brand.
Brake fluid may cause irritation. Avoid contact with skin or eyes.
In case of contact, flush thoroughly with water and call a doctor if
your eyes were exposed.
Checking the oil level
Keeping the motorbike level and upright, check the oil level through the inspec -
tion (1) window on the right crankcase. Make sure the level (a) is about midway
of the sight glass.
To top up, remove the filler cap (2).
Have this operation made with warmed-up engine.
Be careful not to touch hot engine oil.