Husqvarna 2005 HUV4213, Owner'S Manual

Page: 16 / 46

Seat Latch and Adjustment
Page 14 2005 HUV4213 Gasoline Vehicle Owner’s Manual
HEADLIGHT CONTROL
The headlight control is located on the instrument panel between the fuel gauge/hour meter and steering col-
umn. Pull the headlight control knob out to turn the headlights on and push the knob in to turn the headlights
off.
NOTE: Using the headlights for extended periods of time without the engine running, or with the engine
idling, will discharge the battery.
LIGHT BAR CONTROL
The light bar control is a toggle switch located on the instrument panel above and slightly left of the headlight
control knob. Place the toggle switch in the upper position to illuminate the light bar lights and in the lower
position to turn the light bar lights off.
SEAT LATCH AND ADJUSTMENT
The seats are hinged to allow easy access to the engine compartment. A latch at the rear of each seat bottom
keeps the seat from moving on its hinges while the vehicle is in operation. To disengage the latch, grasp the
seat back and pull firmly in a forward/upward direction until the latch releases. To engage the seat latch, push
down firmly on the seat back until the seat locks into place.
See following WARNING.
The bucket seats are adjustable and can be moved forward or backward to accommodate the driver or pas-
senger. To adjust a seat:
1. Remove the seat from the vehicle.
2. Remove the four bolts and washers from the bottom of the seat mounting plate.
3. Align the mounting plate holes with holes in the seat to achieve the desired seat position.
4. Install washers and bolts and tighten to 96 in-lb (10.8 N·m).
5. Install seat in the vehicle.
ý
WARNING
• Make sure seat hinges and latch are securely engaged before operating vehicle.
PRE-OPERATION AND DAILY SAFETY CHECKLIST
Each Husqvarna vehicle has been thoroughly inspected and adjusted at the factory; however, upon receiving
your new vehicle(s), you should become familiar with its controls, indicators, and operation. Carefully inspect
each vehicle to ensure that it is in proper working condition before accepting delivery.
Use the following checklist as a guide to inspect the vehicle. This checklist should be used daily to ensure that
the vehicle is in proper working condition and in conjunction with the Periodic Service Schedule on page 24.
Any problems should be corrected by a Husqvarna distributor/dealer or a trained technician.
• General: All the parts should be in place and properly installed. Be sure that all nuts, bolts, and screws
are tight. Check hose clamps for tight fit and the starter belt for tightness.
• Safety and information decals: Check to ensure that all safety and information decals are in place.
See pages 4 and 5.
• Tires: Check for proper tire pressure. Visually inspect tires for wear, damage, and proper inflation on a
daily basis. See Vehicle Specifications on page 36.
• Battery: Before using vehicle for the first time, check electrolyte to ensure it is at the proper level
(Figure 26, Page 33) . Check battery posts. Wires should be tight and free of corrosion and battery
should be fully charged.
• Engine: Check for proper engine oil level. See Engine Oil on page 27.