11. Attach the center unit to the puller. Tighten the
center bolt and use the holding tool to prevent
movement until the flywheel releases.
8.4.2 To assemble the ignition system
1. Make sure that the keyway in the flywheel and the
keyway in the crankshaft are not damaged. Make
sure that the key is not damaged. Attach the
flywheel and the centrifugal cluth with the spacers
and screws as shown in the illustration.
Note: Turn the clutch until you can see the arrows
that show the turning direction.
2. Assemble the cables (E) to the ignition module (F).
Use the 2 screws (D) and the 2 washers (G) to
assemble the ignition module on the frame.
D
E
F
G
3. Use a feeler gauge to make sure the distance
between the ignition module and the flywheel is 0.3
mm.
4. Assemble the clutch drum and clutch drum cover.
Attach the clutch drum assembly (C) with the 2
screws (A), the 4 screws (B) and the 2 washers.
A
B
C
26 - Repair instructions
675 - 002 - 23.04.2018
