wear on the guide bar, saw chain and chain drive
sprocket increases.
Assembly
To attach the loop handle
1. Attach the loop handle to the shaft in compliance
with the illustration and tighten.
2. Make sure that the loop handle attaches between
the arrows on the shaft.
To assemble the two-piece shaft
1. Turn the knob to loosen the shaft coupling.
2. Move the locking/release button (A) into the
guide recess. Push the attachment into the
coupler until the locking/release button sets into
the primary hole (B).
3. Insert the shaft into the shaft coupling. The
button must go through the hole.
Note:
If the attachment does not go fully into
the upper shaft, use a small screwdriver to push
the internal drive shaft deeper into the tube. It
can be necessary to turn the screwdriver while
you push.
4. Make sure that you fully tighten the knob before
you operate the product.
To attach the pole saw attachment
WARNING:
Stop the product on a
level surface when you install or remove
the attachments.
10
1780 - 001 - 08.02.2022
Summary of Contents for 128PS
Page 78: ...78 1780 001 08 02 2022 ...
Page 79: ...1780 001 08 02 2022 79 ...
