Husqvarna 111280, Operator'S Manual

Page: 12 / 38

12
ASSEMBLY
12. Re-install the pulley shield.
13. Cut the blower housing along the dashed
line to fit the 52" and 61" decks. Drill the
two small holes indicated with the 11/32"
drill bit. The blower housing will fit 42" and
48" units with no modifications. Figure 2.
14. Remove the (4) 1/4 x 3/4 carriage bolts from
the deck plate, and the (4) 3/8" nyloc nuts
from the inside of the blower housing.
Figure 1.
15. Place the deck plate on the welded studs
in the blower housing. Install and tighten
the (4) 3/8" nyloc nuts that were just
removed. Figure 1.
16. Install the (4) 990074, 1/4 x 3/4 carriage
bolts thru the square holes in the deck plate
from the inside out.
17. Place the (4) 990598, 1/4 flat washers and
(4) 108120, 1/4" nyloc nuts on the carriage
bolts. The lanyard must be placed on the
top front carriage bolt between the flat
washer and the blower housing. Tighten
the nuts. Figure 1.
FIGURE 2
61” DECK HOLE
52” DECK HOLE
CUT ALONG DASHED LINES PER DECK
SIZE AND DRILL CORRECT HOLES TO
11/32” PER DECK SIZE.
61” DECK TRIM LINE
52” DECK TRIM LINE