HUSKY INSTRUCTION MANUAL
9
• Remove the two screws (1) that hold the upper hinge (5)(right side) to the frame.
• Lift the door off and place on a padded surface to prevent scratching.
• Remove the blanking plug (8) from the hole in the upper left corner of the door and
transfer it to the uncovered hole on the upper right corner. Press firmly to secure it.
• Remove the two screws (6) that hold the lower hinge (2)
• Remove the adjustable front left foot and transfer it to the other side.
• Remove the bolt pin(7) from the lower hinge (2) and reverse the direction of the
lower hinge. Secure the lower hinge (2) to the left side of the lower frame with the
two screws (6) Re-insert the bolt pin (7). Set the door into position, making sure it is
seated comfortably onto the lower hinge (2).
• Holding the door closed, secure the upper hinge (5) into the top frame with the two
screws (1). Check the door is level and tighten the screws firmly.
Check that the door opens and shuts correctly after you have completed the
door reversal process. The appliance must now be upright for a minimum of 4
hours before switching on again.
MAINTENANCE & CLEANING
Disconnect the appliance from the power before cleaning. Always reconnect the
plug with dry hands. Never pour water over the appliance.
Interior Cleaning
• Wash the interior with warm water and neutral detergent such as bicarbonate of soda
(5ml to 0.5 litres of water)
• Do not use abrasive products, detergents or soaps
• Wipe the wooden shelves with the same solution.
• Dry all surfaces thoroughly.
Exterior Cleaning
• Wash the outer cabinet including the back and bottom of the appliance with warm
soapy water.
• Do NOT use abrasive products as this can damage the finish
• Once or twice a year dust the compressor at the back of the appliance with a brush
or vacuum cleaner to maintain efficient performance
• Dry all surfaces thoroughly.
WHEN YOUR APPLIANCE IS NOT IN USE
If the appliance is not being used for long periods:
• Unplug your appliance
• Clean and dry the inside of the appliance. Leave the door slightly open to allow it to
dry completely
• An appliance which is unused without being cleaned may start to smell musty or
develop mildew.
DEFROSTING
The surface of the evaporator ices up when the appliance is working normally. It can also occur
when the door has been left open or the thermostat has been set too high. If the frost layer is
more than 3mm/
1
⁄
8
" thick, the appliance must be defrosted and cleaned to avoid unnecessary
energy consumption and inefficient operation.
HUS-HM39-HN-M manual 0720.indd 9
HUS-HM39-HN-M manual 0720.indd 9
02/07/2020 14:17
02/07/2020 14:17
