HUSKY INSTRUCTION MANUAL
7
TO OPERATE
• When the appliance has been positioned, adjust the feet to ensure the unit is stable.
This is essential to ensure quiet running and proper door opening/closing
• Ensure that the appliance is not connected to the power and clean the interior
compartment following the instructions on page 9
• Remove all transportation tapes
•
CONNECT TO THE ELECTRICAL SOCKET BUT DO NOT SWITCH
ON THE POWER FOR AT LEAST 4 HOURS.
The coolant within the product
needs time to settle after it has been transported and put in to position. Failure to do
this will affect the cooling performance of your appliance
• Follow the instructions below to adjust the thermostat to the required temperature.
Leaving the thermostat at 0 will mean that the appliance will not start operating
• There may be an odour when you first switch on the appliance, it will disappear as it
starts to cool
• The following sounds are perfectly normal:
• Faint gurgling or bubbling sounds as the refrigerant is pumped to the cooling
system
• A slight whirring or pulsating noise as the compressor is working
• A slight click as the thermostat cycles in and out and controls the compressor
• After the appliance has been unplugged, leave for 15 minutes before plugging it in
again.
TEMPERATURE SELECTION
The adjustable thermostat is situated on the inside of your appliance on the lower right hand
side. This can be rotated left or right to adjust the temperature.
On the thermostat, 1 is the warmest and 5 is the coldest.
The thermostat should be adjusted according to the amount of product in the fridge and the
ambient temperature. The guide for setting the thermostat is as follows:
Winter — Setting 1-2
Spring and Autumn — Setting 2-4
Summer — Setting 4-5
The first time you switch the unit on, set the temperature control to the “5” position. After
24-48 hours, adjust the temperature to the setting that best suits your needs. To turn the unit
off, turn the temperature control to “0”.
Note:
turning the temperature control to “0” stops the cooling cycle but does not shut the
power off from the unit. If the unit is unplugged, turned off, or in case of power failure, you
must wait 15 minutes before restarting the unit. If you do not wait, the unit may not start.
WARNING:
If the thermostat is set to too cold a setting, beverages may become frozen. In
extreme circumstances, glass bottles may even break. Always exercise caution when setting the
temperature.
CLIMATE CLASSES (see rating plate)
CLIMATE CLASS
AMBIENT AVERAGE TEMPERATURE °C
SN
+10 to +32
N
+16 to +32
ST
+16 to +38
T
+16 to +43
HUS-HM39-HN-M manual 0720.indd 7
HUS-HM39-HN-M manual 0720.indd 7
02/07/2020 14:17
02/07/2020 14:17
