6
CUB300LH, CUB300RH & CUB500H Display Chillers
Operating Instructions
TO OPERATE THE ELECTRONIC THERMOSTAT
Connect the appliance to a power outlet and press the Power switch.
The thermostat has been pre-set, and in most cases it is not necessary to adjust the settings.
When the appliance is operating normally, the display will show the current temperature.
To display the set temperature press the
button. Press the button again to return to
normal operation.
To set a new temperature, press
. The display will flash and the current set temperature
will be displayed. Press the
button to increase the set temperature, or press the
button to decrease the set temperature. Press the
button to save the new setting. The
display will flash with the new temperature and then revert to display the cabinet temperature.
Please note:
1. When the appliance is connected to the mains for the first time there will be a short
delay before cooling starts. During this time the Refrigeration Light will flash. After the
short delay, cooling will begin and the Refrigeration Light will be illuminated. When the
appliance reaches the set temperature, the Refrigeration Light will turn off.
2. If you do not press any button, after six seconds the controller will return to its normal
display.
ALARM CODES
PF1 flashing in the display indicates that the cabinet sensor is defective. The appliance will
attempt to maintain the set temperature until the fault is repaired.
PF2 flashing in the display indicates that the evaporator sensor is defective. This does not
compromise the operation of the appliance, but the fault should be repaired as soon as possible.
DEFROSTING
The appliance defrosts automatically at preset intervals. If however the doors are opened too
often, or if the appliance is in a location with high humidity, or if the contents are changed more
frequently, it may be necessary to defrost the appliance manually. To start or stop manual
defrosting, press the button for six seconds. The Defrosting Light will be illuminated. Melt
water runs to a container placed in the compressor compartment and evaporates. After
defrosting is complete, the appliance will return to normal operation.
Technical Support: 01455 555340 (UK)
CUB300_CUB500 Display Cabinet Range manual 0418 v2.indd 6
19/04/2018 08:54
