09
En
glis
h
8.
When the Screw Stops during Operation
01
01
02
02
01
For 2 to 3 times, repeat the process of pressing
the operation switch in the [REV] direction for 3
to 5 seconds and then releasing it.
The reverse
rotation [REV] is a function that returns and lifts the
ingredients upward. It only works when the switch is
being pressed in the [REV] direction, and the screw
rotation stops when the switch is released.
02
After the screw is completely stopped after
reverse rotation, press the operation switch in the
[ON] direction to start the operation again.
When operating the extraction [ON] or reverse
rotation [REV] function, completely stop the screw
first and then operate the switch in the direction of
the function to be operated next.
Note
If it does not work even after following the above
steps, unplug the power cord from the outlet,
remove the chamber set, wash it, and use it again.
The motor will continue to spin after the machine
is turned off but it will slow down and come to a
complete halt.
누름
정회전
역회전
작동스위치
정회전
역회전
누름
정회전
역회전
작동스위치
정회전
역회전
정회전
역회전
정지상태
작동스위치
정회전
역회전
off(정지)
정지
01 Open the hopper cover.
①
Press the lever of the hopper cover to open it.
Overloading the product with ingredients may
damage the product.
02 Add the juicing ingredients below the limit mark
of the hopper.
①
Use soft ingredients by mixing them with others.
03 Close the hopper cover and keep the juice cap
open.
①
Before pressing the extraction switch [ON], put a
juice cup in place first.
②
The juice can flow backwards into the hopper if
the juice cap is closed. If the juice does not come
out even after opening the juice cap, then open the
hopper cover and remove the content.
04
Press the operation switch [ON] to start
operation.
①
The "click" sound when the product is operating
is the sound of the chamber set and the motor
binding together.
05 To add more ingredients during operation, use
the additional inlet or open the hopper cover.
①
Operation stops when the hopper cover is open.
②
Do not use anything other than the designated
pusher.
③
In case the ingredients spin but fail to be ground up
in the hopper during extraction, use the pusher to
press the ingredients down.
06 Let the machine operate for about 1 more minute
after all ingredients go down in the hopper.
①
It slowly presses and squeezes the ingredients so it
takes some time until the last ingredient is juiced.
②
Removing the remaining pulp by additionally
operating the machine after extraction makes it
more convenient to detach the hopper and clean
the parts.
07 Once the juicing and pulp removal are finished,
press the power switch to stop the machine.
①
The machine stops 3 seconds after it is stopped by
pressing the power switch.
08 Pour any remaining juice by tilting the chamber
forward.
①
For thickly concentrated juice made of tomatoes,
etc., the juice may still remain in the chamber.
