HUR PULLEY, User Manual, Page: 10 / 21

9
ver. 1/2017
2.4 Installation
HUR recommends that the installation of HUR Pulleys is performed by authorized HUR technician.
In that case the reliability of the installation will be reached. HUR technician has all needed tools and in-
structions for installation and also has knowledge of all special characteristics of each machine.
HUR devices are designed only for inside use. Devices must not get wet and it’s recommendable to avoid
moisture. All models with electronic components should be left to acclimate to room temperature for
about an hour before installing or operating, if the transportation or storage has been in a cold place.
Equipment should be placed on a hard, flat and straight surface. To avoid malfunction, keep the unit in a
dry place and at constant temperature protected from dust.
WARNING! Floor mounted equipment shall be installed on a stable and levelled base.
Hur Pulley floor mounted models 8831, ST8831 MUST BE ATTACHED TO FLOOR.
2.5 Adjusting Pulley
Pull the orange handle located on the side of the cable
column and adjust the height by moving the cable
column up or down. Make sure that the cable column
is properly locked.
WARNING! Make sure that the rod of the
handle slides properly back inside to its slot
after adjusting the cable column. Otherwise, the cable
column may move and cause a dangerous situation.
If you need the support handles, pull the orange han-
dle next to the frame and adjust the handles to desired
level. Make sure that the rod of the handle slides back
to its slot.