Operating Instructions
Hotplate
Page 14
EN
7 Assembly and electrical connection
7.1 Assembling the hotplate
CAUTION
Injuries caused by sharp edges
The mounting frame and base of the product, as well as the surface,
may have sharp edges.
►
Wear suitable protective gloves when transporting and
installing the product.
The hotplate is permanently installed in a counter with a suitable
substructure for support; the display is installed separately in the same
counter or the optional heated lamp gantry. The counter must have a
lockable inspection opening that allows access to the base of the
hotplate and, if necessary, the power supply.
Once assembly is complete, the warning labels supplied with the
product must be affixed to the counter in a clearly visible position in the
immediate vicinity of the product.
Information on the layout of cut-outs and supports and the necessary
assembly work can be found in the separate assembly instructions.
Depending on the version with or without mounting frame, an
additional sealing of the hotplate is required after assembly. Please
observe the information in the assembly instructions.
7.2 Electrical connection
The electrical connection of the hotplate is made via a hard-wired
connection at the installation site. The control unit and, if necessary, a
heated lamp gantry are permanently connected to the hotplate.
For information on the layout of the connection and connection
diagrams, please refer to the separate assembly instructions.
The connection must be carried out by a trained electrician.