Note
If end limits were already set, the motor will not jog, indicating the motor direction did not change.
Note
Verify that all GROUP lights are turned off on the remote, clear both limits, and try again.
3.2. Check and con
fi
rm
IMPORTANT
Watch out to perform steps 3.2.1 and 3.2.2 immediately after each other to avoid mechanical damage!
Carefully read them
fi
rst before executing!
3.1.3
Press and release
the
stop
button.
Make sure
no group
on the remote is
selected.
The blind will jog 2x to indicate it
has reversed motor direction
3.1.4
Release
the
manual control button
.
Page 6 of 18
version: 1.0
