Hunter TCX56, Operating Instructions Manual

Page: 55 / 68

Operation Instructions for TCX56/57 Tire Charger 55
3- Position the tool head manually against the edge of the rim.
4- Keep the roller in contact with the edge of the rim, alternately loosen and tighten the two
hex bolts until there is no gap.
5- When the correct position has been achieved, tighten the hex bolts alternately to lock it in
position.
6- Tighten the head retaining bolt.
Adjust the Offset of Lock Mechanism – Steel and Plastic Heads
1- Again, position the mount/demount head on the outer edge of upper rip lip and lock in
this position.
2- Use gauges to measure distances between head and the top of the rim. Measure at
inserts on steel head
TIRE MOUNTING LIP
TOP GAP
Measure with feeler gauge
5/64-inch specification
TIRE DEMOUNTING LIP
SIDE GAP
Measure with feeler gauge
5/64-inch specification
Change the offset by removing the plastic cover and adjusting the nuts located on front of
the locking mechanism.
Replace the plastic cover.
Confirm head clearances to the 17-18” in rim are correct. Position the mount/demount head
on the outer edge and lock in this position. Check clearances.