Hunter TCX56, Operating Instructions Manual

Page: 19 / 68

Operation Instructions for TCX56/57 Tire Charger 19
Walk around the machine to ensure that all components are in good condition and
operational, and that there are no foreign objects or debris (rags, tools, etc…) in or about the
machine which could affect its operation.
These checks must be carried out:
• Before starting the machine.
• At regular time intervals.
• After any modification or repair.
The machine may only be started after this pre-use check is successfully completed.
Do not use the machine if it is placed out of service for tune up, maintenance, lubrication,
etc.
1.8 During Use
In the event you hear any strange noise or feel unusual vibration, if a component or system
is not operating properly, or if there is anything unusual at all, stop using the machine
immediately.
• Identify the cause and take any necessary remedial action.
• Contact your supervisor if necessary.
Never allow any bystander to be within 20 feet of the machine during operation.
To stop the machine in an emergency:
• disconnect the power supply plug;
• cut off the compressed air supply network by disconnecting the shut-off valve (snap
coupling).
1.9 Control Pedal Configurations
Avoid unintended machine moviment and personal injury.
Pay close attention to the configuration of your machine.
WARNING
Control pedals on the TCX56/57 tire changer are configured as shown below:
NOTICE
If the unit is equipped with a wheel lift, there is an additional pedal at the far right
upper portion of the face of the unit.