18
The ROAM System will allow you to remotely turn
on and off any station on your Hunter controller with
the press of a button. Once on, the station will run
for the run time you have designated in the remote.
To remotely activate a station or program follow the
steps below:
1. Plug the receiver into a SmartPort
®
that is
connected to a powered controller. The receiver
will beep 4 times followed by a 10-second pause
and a single beep.
2. If your transmitter is not on (no display), press
any button for at least one second and release.
The Transmitter will display the active station.
3. Use the
and
buttons to display the
station or program you would like to start.
4. Press the button to start the station or
program. The Transmitter will display the
Transmit icon . If you are near the receiver,
you will hear it beep 2 times. This indicates that
the Receiver has received the command.
aCTiVaTinG a sTaTion WiTH THe RoaM ReMoTe
ConTRol sYsTeM .............................................................................
5. Press the button to turn off any station that
is on. The display will show the Transmit icon
and receiver will beep again twice. The ROAM
System is designed to turn on one station at a
time (unless you activate a program). Therefore,
turning a station on while another station is
operating will cause the operating station to turn
off.
NOTE: The ROAM remote can activate
any station on the controller whether
the controller dial is in the “SYSTEM
OFF”, “RUN” or “RUN/BYPASS
SENSOR” modes. If a sensor device
has been wired to the controller, the
ROAM remote will NOT override the
sensor for manual operation.
Summary of Contents for Residential/Light Commercial Remote Control System
Page 2: ......
Page 6: ...TRANSMITTER RECEIVER SmartPort 2 ROAM COMPONENTS ...
