16
As stated earlier, your ROAM System is designed
to work right out of the box. If you have decided to
change your Transmitter address as described in
the previous section, you must allow the Receiver
to “learn” this new address. Once learned, the only
way to remove the address from Receiver memory
is to learn a different address. This can be done by
following the simple steps outlined below.
PRePaRinG THe ReCeiVeR foR use ............................................
NOTE: The ROAM remote receiver
should not be permanently installed
in an outdoor or unsheltered location.
Summary of Contents for Residential/Light Commercial Remote Control System
Page 2: ......
Page 6: ...TRANSMITTER RECEIVER SmartPort 2 ROAM COMPONENTS ...
