Hunter 49, Operator'S Manual

Page: 87 / 196

Hunter 50 • Underwater Gear
6.5
Care should be taken that these intakes and pick ups are
cleaned of barnacles and other growth as specified in the
maintenance section of this manual to maintain a clear,
open passageway.
The optional electronics package you have ordered on
your boat will largely determine the underwater gear that
is related to the monitoring equipment. Be sure and refer
to your documentation in your owner’s packet to find out
the details about this equipment.
6.4 Windlass and Anchoring (Option)
6.4.1 Windlass
The windlass facilitates the anchoring of your boat by
automatically raising and lowering the anchor. To oper-
ate the windlass, the windlass breaker at the battery
seitch panel must be switched on.
Note: It is important that the windlass clutch is tight for proper
operation and safety. Periodically check the clutch and tighten
if necessary.
To tighten the clutch:
With the anchor in the stowed position, tighten the
windlass clutch by inserting the emergency handle in
the clutch nut. (See fig 6.9) and turn clockwise.
To Operate Manually:
Make sure that the safety hook is removed from the
anchor chain.
•
Insert the emergency han-
dle into the clutch nut.
Turn handle clockwise
to retrieve anchor.
To operate from the
bow:
Switch the power on at
the controls
Remove the safety
hook
Lift the protective cap
from the foot switch and
depress the up or down
switch for the
desired result.
Maintenance:
DANGER
! !
Make sure that the power is off before performing
any maintenance or work on the windlass.
Periodically check the motor and control box electrical
connections, remove any residue and cover connections
with a small coating of grease.
It is recommended that you, once a year, disassemble
the windlass and remove residue buildup. To perform
this maintenance follow all safety procedures and com-
plete the following:
Using the emergency handle, unscrew the nut by
turning the handle counterclockwise.
Remove the drum, upper cone, chain wheel, and
lower cone.
Wash down with water to remove any residue
Coat surfaces with a light film of lubricant
Reassemble the unit and tighten the clutch by turning
the handle clockwise.
Note: Refer to your Owner’s / Operator’s Manual in your own-
er’s kit for detailed information about your windlass.
•
•
•
•
•
•
•
•
Fig. 6.8
Emergency Handle
Clutch Nut
Drum
Upper Cone
Chain Pulley
Lower Cone
Windlass Profile Illustration
Fig. 6.9