Hunter 49, Operator'S Manual

Page: 24 / 196

Hunter 50 • Documents and Forms
DEALER: _____________________________ ENGINE:_________________________________
MAKE:_______________________________ OWNER: ________________________________
PORT ENGINE NO: ____________________ STBD. ENGINE NO: _______________________
BOAT
A A NAME:__________________________REGISTRY R R NO:_________________________
___
OPERATION___________INITIALS________ A A OPERATION____________ A A INITIALS_________
COMMENTS:____________________________ __ ________________________________________ __
_______________________________________________________________________________
INSPECTION DATE:____________________ AA __ __
DEALERS SIGNATURE: _______________________________________________________
OWNERS SIGNATURE: AA ___________________________________________________________
BEFORE LAUNCHING
WITH BOAT A A IN WA W W TER A A
13. Hose test for cabin and window leaks
14. No water leaks at thru hull fitting
with seacocks
15. No water leaks at shaft or rudder
16. With all switches offff - no spark when
battery cable touched to post
17. All electrical equipment operating
including: horn( ); running light( );
bilge pump( )
18. Toilet TT operates
BEFORE
S
TARTING TT
E
NGINES
23. All engine wiring in good order & tight
24. Throttle control and cable travel
25. Clutch control and cable travel
26. Crankcase oil level at FULL mark
27. Reverse gear oil level at FULL mark
28. No fuel leaks in fuel lines, at fittings, at
fuel filter, fuel pump
29. No engine water or oil leaks
30. Oil pressure and exhaust water flow
31. Idling speed set at 700-800 RPM
and is in proper adjustment
WA W W TER A A TEST BOAT A A
33. Engine performance
34. Instruments are registering properly
35. Top TT RPM wide open throttle for one
minute after warm-up
36. Boat performance
FINAL CHECK:
37. All accessory equipment operating
19. Water (pressure) system operates
20. Galley stove operates
21. With fuel tanks full, no fuel leaks at
fill pipes, overflow vent, or at
any fuel line connections
22. With coupling disconnected, engine and
shaft alignment
38. Carpets and drapes installed and clean
39. All loose equipment on boat
ready for new owner.
Pre-delivery Service Record
Fig. 2.1
1. Hull Side Clean and Gelcoat
2. Bright work clean and finish
3. Decks cleaned and gelcoat
4. Interior Finish
5. Upholstery clean and carpet in place
6. Bilge cleaned.
7. Bottom clean and paint
8. Both shafts turn freely
9. Engines and Generator intakes installed
10. All hull fittings sealed
11. All drain plugs tight, (hull, engines, generator, muffler)
12. Sacrificial Anodes installed
2.10