Hunter 41462-01, Installation And Operation Manual

Page: 18 / 26

18
41462-01 10/14/2005
®
STEP 9 - REMOTE CONTROL STEP 9 - REMOTE CONTROL
STEP 9 - REMOTE CONTROL STEP 9 - REMOTE CONTROL
STEP 9 - REMOTE CONTROL
REMOTE CRADLE INST REMOTE CRADLE INST REMOTE CRADLE INST REMOTE CRADLE INST REMOTE CRADLE INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION
ST ST
ST ST
STANDARD LIGHT SWITCH ANDARD LIGHT SWITCH
ANDARD LIGHT SWITCH ANDARD LIGHT SWITCH
ANDARD LIGHT SWITCH
1. Remove the two screws holding
the switch cover plate. Do not re-
move the cover plate.
2. Orient the control cradle as
shown in Figure 9a, and line up
the two inner mounting holes
with those on the switch, insert
screws, don't over tighten.
Figur Figur
Figur Figur
Figure 9a e 9a
e 9a e 9a
e 9a Figur Figur
Figur Figur
Figure 9b e 9b
e 9b e 9b
e 9b
ROCKER LIGHT SWITCH ROCKER LIGHT SWITCH ROCKER LIGHT SWITCH ROCKER LIGHT SWITCH ROCKER LIGHT SWITCH
1. Break off the two tabs by push-
ing outward. See Figure 9b.
2. Remove the two screws holding
the switch cover plate. Do not re-
move the cover plate.
3. Orient the remote cradle as
shown in Figure 9b. Line up the
two outer mounting holes with
those on the switch , insert
screws, don't over tighten.
WALL INST WALL INST WALL INST WALL INST WALL INSTALLA ALLA ALLA ALLA ALLATION TION TION TION TION
1. Locate a 2x4 wall stud in a conve-
nient location.
2. Orient the remote cradle as shown
in Figure 9c, over the 2x4 stud.
3. Use the 1” wood screws in either
the inner or outer mounting holes.
Note: Note:
Note: Note:
Note: Wall anchors and 6-32 x 1”
screws may be used in situations
where mounting to a stud is not pos-
sible. Use the inner mounting holes.
Figur Figur Figur Figur Figure 9c e 9c e 9c e 9c e 9c
Remove tabs