8
42700-01 • 01/15/08 • Hunter Fan Company
5 • Assembling and Hanging the Fan
Steps 5-4 – 5-5
Low Profile Screw
Low Profile Washer
Steps 5-1 – 5-2
Downrod
Canopy
You can assemble your fan for standard mounting (steps 5-1 – 5-2)
or for low profile mounting (steps 5-3 – 5-5).
Note:
For low profile
mounting, the downrod is replaced with the low profile washer.
5-1. To assemble fan to hang down from a flat or angled ceiling, insert
the downrod through the canopy. Feed the wires from the fan
through the downrod.
5-2. Loosen the square head set screw on the adapter to install the
pipe and ball assembly.
Note:
When the pipe and ball assembly
is fully installed, 2-3 threads on the pipe will still be visible; this is
normal. Securely retighten the set screw with a wrench or pliers.
Skip to Step 5-6.
CAUTION:
The adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing. Once assembled, do not remove the downrod.
5-3. Remove the set screw from the adapter.
5-4. Place the low profile washer (lip down) into the canopy. Be sure
the green ground wire is pointing up toward the ceiling.
5-5. Align the holes in the washer with the holes in the adapter.
Assemble securely with three low profile screws.
Note:
Before hanging the fan, align and engage the two tabs from the
bottom of the canopy and the two grooves in the hanger ball.
5-6. Raise the fan and place the hook on the ceiling plate through the
round hole in the rim.
WARNING:
Fan may fall if not assembled as directed in these
installation instructions.
Step 5-6
Round
Hole
