10
42700-01 • 01/15/08 • Hunter Fan Company
7 • Wiring the Fan
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
Wall switches are not included. Select an acceptable general-use switch
in accordance with national and local electrical codes.
7-1. Disconnect the power by turning off the circuit breakers to the
outlet box and associated wall switch location.
7-2. Place the receiver inside the canopy, making sure that the
dipswitches and the oval shaped holes in the bottom of the
receiver are facing down toward the bottom of the canopy.
7-3. Spread the receiver lead wires to each side and feed the wires from
the top of the fan through the open slot in the receiver.
7-4. Place the receiver in the canopy. Make sure the slot in the receiver
is aligned with the hook in the ceiling plate.
7-5. To connect the wires, hold the bare metal leads together and
place a wire connector over them, then twist clockwise until tight.
Using the small wire connectors, connect the fan to the receiver as
follows:
• Connect the yellow wire from the fan to the yellow wire from
the receiver.
• Connect the pink wire from the fan to the pink wire from the
receiver.
• Connect the grey wire from the fan to the grey wire from the
receiver.
• Connect the red wire from the fan to the red wire from the
receiver.
• Connect the black wire with a white stripe from the fan to the
black wire with a white stripe from the receiver.
• Connect the white wire from the fan to the white wire
(LIGHT OUT) from the receiver.
Steps 7-5 – 7-6
Large Wire
connector
Small Wire
connector
