Hunter Stoves AVALON 4 Series, Instructions For Installation/Operating/Maintenance/Servicing

Page: 16 / 28

16
OPERATING THE APPLIANCE
Please see instructions on page 21 for pairing the handset to the valve. It is strongly recommended
that these instructions are read and thoroughly understood in advance of operating this appliance.
Gas Control Cover Plate
To gain access to the gas control valve, the cover plate must first be opened. The cover plate opens from
the left and swings out, away from the stove to expose the gas controls.
Burner Controls
The gas control valve is situated at the front on the left-hand side of the appliance, behind the gas
control cover plate.
Pilot Assembly
The pilot assembly is positioned at the front of the burner tray on the right-hand side
.
IMPORTANT NOTE
The fitted with a spillage system (TTB), which is in close proximity to the draught diverter and operates
to shut the appliance off if the evacuation of combustion products is interrupted (for example caused by
lack of flue pull or flue blockage).
If this occurs, restart the appliance (as detailed in the “L ighting the Appliance” section, page 16).
If the spillage system repeatedly operates to shut the appliance down, a GAS SAFE registered engineer
should be contacted to examine the appliance and installation.
CARE, MAINTENANCE AND SERVICING
Check your chimney and flue arrangement and have the chimney system swept at least once a year.
Painted Appliances
Painted Finish - The stove is finished with a heat resistant paint and this can be cleaned with a dry
microfiber cloth. Do not clean whilst the stove is hot. At no point should any water based, or other
cleaning products be used on the stove. The finish can be renovated with Hunter Stoves paint,
available either through our website www.hunterstoves.co.uk/spares or through your local supplier.
Glass Panel
Clean the glass panel when cool with a propriety glass cleaner by applying the cleaner to a cloth. Do
not apply directly to the glass as this could cause run of which could soak into the rope seals around the
edge of the glass.
Highly abrasive substances should be avoided as these can scratch the glass and make subsequent
cleaning more difficult.
Door/glass/rope replacement should only be carried out by a Registered Gas Safe Engineer.
Servicing
A GAS SAFE registered fitter must carry out an annual service and where necessary replace
unserviceable components with only genuine Hunter Stoves Gas parts.
Service Records can be kept on the following page for your convenience.