OPERATION
9
Problem
The universal cordtensioner grabs onto the cord upon operation.
Solution
Check that the universal cord tensioner is mounted properly. Reinstall, if
necessary. See
the
Universal Cord Tensioner Installation Instructions
that came
with your Cord Tensioner Kit
.
Problem
The shade fabric winds unevenly on the roll.
Solution
■
Check that the shade is level.
■
Completely lower the roller shade, then raise it slowly.
➤
If the fabric winds unevenly and begins to telescope to one side, check to
ensure that the shade is level.
➤
If the shade is not level, remove it from the installation brackets and shim
or re-install the brackets, as necessary.
Important:
If the shade was unrolled before being installed, it may not raise
and lower to the right points. To correct this:
■
Remove the shade from the mounting brackets.
■
Roll the shade up until the bottom rod is even with the bottom of the clutch.
■
Re-install the shade.
Problem
The shade is slightly long or short.
Solution
■
Raise the shade completely (until the bead stop touches the back of the
clutch).
➤
For a shorter drop, move the bead stop two to four beads down.
➤
For a longer drop, move the bead stop
two to four beads up.
Important:
Maximum adjustment is
1
3
/
4
", or eight to nine beads.
Bead
Stop
Summary of Contents for Provenance
Page 1: ...Installation Operation Care Provenance Woven Wood Roller Shades ...
Page 14: ...Notes ...
Page 15: ......
